JFEbWJKvqRf

Имя (желательно полное):

E-Mail:

URL:

Город:

Страна:

Вежливый и подробный комментарий:
(Форматируйте его, пожалуйста, как почту - короткими строками
Еnter в конце строки, пустая строка между параграфами).
> The stand has a magnetic on/off and holds well on the solid metal lathe surface. It is not on the zero mark but I think it is made this way since you will place the needle against the item you want to level and adjust to zero. You will want a negative reading also, for low spots on your work, so even if this was on zero to start you would need to push the needle in a full turn on the and back to zero anyway to enable a negative reading. This works well for my uses. Good for reloading and work on my lathe. I would recommend to anyone.

Пожалуйста, заполните все поля.
И не нажимайте по два раза на кнопку! Дождитесь ответа сервера.

[an error occurred while processing this directive]